Keep the target area dry first, precisely spray the mold removal cleaner point-to-point, cover with paper towels to wet compress and let it sit for 15 to 30 minutes, then gently scrub with a soft brush and rinse thoroughly with plenty of clean water.
Cracking the deep structure of mold
The black spots visible on the bathroom surface are just the tip of the iceberg; mold hyphae often penetrate into tile gaps and silicone. Relying only on surface spraying and wiping cannot eradicate the problem, and incorrectly scrubbing too early may further push the hyphae into the capillaries of the building materials, causing it to return.
When handling moldy materials, you can follow US Environmental Protection Agency's home mold prevention recommendations(opens in a new window)treatment and note the on-site and material restrictions.
Mold removal operation safety rules
Before performing any cleaning, please be sure to test whether the cleaner has a fading reaction on the building material, and wear gloves. Strictly forbid mixing mold removal agents with bleach or other acidic cleaners; otherwise, extremely dangerous gases will be produced. Be sure to turn on the exhaust fan during operation to ensure environmental ventilation.
Wet compress sitting method steps
To achieve eradication, the sitting time is key. For stubborn black mold, it is recommended to cooperate with the following physical water-locking method:
- Keep the target part completely dry.
- Precisely spray the right amount of mold remover at the black mold.
- Lay on kitchen paper towels and lightly spray a little bit of the agent to make it completely moist, forming a tight fit like a facial mask.
- Let sit for 15 to 30 minutes to allow chemical components to thoroughly break down the hyphae.
- Gently brush along the gaps with a soft toothbrush.
- Rinse the residual agent thoroughly with plenty of clean water.
Daily maintenance and professional support
Mold prevention is more important than anything. After showering, you should use a squeegee to clean water droplets on the wall and keep it ventilated. If the mold area is too large or has penetrated deep into the interior, DIY treatment effects are limited; it is recommended to contact 壹家壹清潔專家 for safe deep mold removal using professional equipment.
Address mold promptly and keep the area thoroughly dry; porous materials with severe mold may need to be removed.
